| |
|
Un-branded RF Load
DC-1 GHz 200 Watts
Possibly Cellwave, 50 Ohm, tested OK to 1 Ghz. 100 Watts continuous, 200 Watts 50% duty cycle. With a fan the ratings can be higher up to 200 Watts continuous. Type N(F) input connector.
|
|
|
|
| |
|
Cellwave RF Load 250 Watts PEP - 60 Watts Continuous & RF Tap
250W PEP for SSB, 62.5 Watts CW. 50 Ohm dummy load, DC to 2.5 Ghz type N Female input and a -30 to -60 dB counter/scope tap (attenuation varies with frequency) on a 10 BNC cable. Take measurements with your counter while the transmitter is at full power. SWR is less than 1.05 from DC to 2500 MHZ.
|
|
|
|
| |
|
Cellwave RF Load 250 Watts PEP - 60 Watts Continuous
Same as above except no RF Tap and has a N Male Connector
|
|
|
|
| |
|
Cellwave 300 Watts RF Load DC-1.3 GHz
RF Load 300 Watts continuous, 50 Ohms, tested flat to 1.3 GHz. Dry RF load, add a fan to increase power dissapation to >300 Watts. Type N female input connector. Used in excellent condition. mounting screws.
|
|
|
|
| |
|
Decibel DB4303B 100 Watt RF Load
DB4303G Type N male connector resistive 50 Ohm load HF/VHF/UHF. 100 Watts. Used in good to excellent condition. Similar to Bird 8164.
|
|
|
|
| |
|
JFW Attenuator 50FHC-030-50
30dB 50 Watts 4 GHz
JFW Model 50FH-030-50 RF attenuator and RF load. N(M) input, N(F) output port.
- Frequency Range DC-4000 MHz
- Impedance 50 Ohms nominal
- VSWR 1.25:1 maximum
- Attenuation 30 db
- Accuracy +/- 0.75 dB
- RF Input Power 50 Watts average @ +25 deg C
- Peak Power 1000 Watts
Full Specifications
Used in like new condition.
|
|
|
|
| |
|
JFW RF Attenuator 6db 250 Watts (NEW)
JFW Model 50FHA0-006-250
JFW Model 50FHA0-006-250 RF Attenuator and 250 Watt RF load. N-male input, N-female attenuator output port. Fifteen pounds, 10-1/4" long and 5-1/2" in diameter.
- Frequency Range DC-1500 MHz
- Impedance 50 Ohms nominal
- VSWR 1.3:1 maximum
- Attenuation 6 db
- Accuracy +/- 0.4 dB
- RF Input Power 250 Watts average @ +25 deg C
- Peak Power 1000 Watts
|
|
|
|
|
